Step 9. Configure The Calpods; Step 8. Confirm The Settings On The Calpod Controller - Keysight CalPod 855 A Series Service Manual

Usage Information
Setup and Use of Keysight 855xxA/B Series CalPods

Step 8. Confirm the Settings on the CalPod Controller

Use either of the following methods to run the IP setup utility and confirm the
default settings shown in the table below.
Method 1: Using the PNA front panel HARDKEYs and [softkeys].
— On the PNA, press CAL > [More] > [CalPod] > [CalPod].
— On the dialog window titled "Calibration Module Refresh Configuration," click
[CalPod Setup].
— On the dialog window titled "CalPod Setup," click [IP Setup].
Method 2: Using the mouse and the PNA pull-down menus.
— On the PNA, click Start > Programs > CalPod > API > IP Setup.
If the default settings are not correctly displayed, use the keypad to enter them in
the IP Setup dialog window.
The default addresses for the 85523B CalPod Controller are shown in the following
table.
Setting
IP
Network mask 255.255.255.0
Gateway
DNS
For additional information on making connections to the LAN using network
switches and network hubs, contact your network administrator.

Step 9. Configure the CalPods

1. Connect each CalPod to the CalPod controller, as shown in the following
graphic.
85563-90005 Operation & Service Guide
Default Address
192.168.0.100
192.168.0.1
0.0.0.0 (or leave
blank)
1-15