How To Select A Multi-Trace Configuration; How To Activate A Trace In Order To Change A Setting; How To Maximize The Viewing Of The Active Trace; Quick Settings - Keysight A Series User Manual

NA (Network Analyzer) Mode
NA Mode Settings

How to select a multi-trace configuration

1. Press Trace 6 >
2. Then choose from the following:

How to activate a trace in order to change a setting

— Use the
— Press Trace 6 then select

How to maximize the viewing of the active trace

1. Press System 7 >
2. Press any key to return to the standard display.

Quick Settings

Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus.
106
Num of Traces
The default measurements depend on the options that are installed
arrows OR
that are shown can be activated.
Full
x1
1 trace standard configuration
x2 2 traces overlayed on a single graticule
x2H
2 traces on separate graticules
x3H 3 traces on separate graticules
x3 3 traces overlayed on a single graticule
x4 4 traces overlayed on a single graticule
x4H 4 traces on separate graticules
Trace 1, Trace 2, Trace
Screen.
Keysight N9927-90020 User's Guide
3, or Trace 4, Only traces