Test Cam Usage; View Cam-Acl Settings - Dell S4048–ON Configuration Manual

cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number l2qos number
l2pt number ipmacacl number vman-qos | vman-dual-qos number ecfmacl number nlbcluster number
ipv4pbr number openflow number | fcoe number iscsioptacl number [vrfv4acl number]
NOTE: If you do not enter the allocation values for the CAM regions, the value is 0.
3 Execute write memory and verify that the new settings are written to the CAM on the next boot.
EXEC Privilege mode
show cam-acl
4 Reload the system.
EXEC Privilege mode
reload

Test CAM Usage

To determine whether sufficient CAM space is available to enable a service-policy, use the test-cam-usage command. To verify the
actual CAM space required, create a Class Map with all required ACL rules, then execute the test cam-usage command in Privilege
mode. The Status column in the command output indicates whether or not you can enable the policy.
Example of the test cam-usage Command
Dell#test cam-usage service-policy input test-cam-usage stack-unit 2 po 0
Stack-Unit| Portpipe|CAM Partition|Available CAM|Estimated CAM per Port|Status
------------------------------------------------------------------------------------
2 | 0
Dell#

View CAM-ACL Settings

The show cam-acl command shows the cam-acl setting that will be loaded after the next reload.
Example of Viewing CAM-ACL Settings
Dell(conf)#do show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
Ipv4Qos :
L2Qos :
L2PT :
IpMacAcl :
VmanQos :
VmanDualQos :
EcfmAcl :
FcoeAcl :
iscsiOptAcl :
ipv4pbr :
vrfv4Acl :
Openflow :
fedgovacl :
-- Stack unit 0 --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
Ipv4Qos :
|IPv4Flow |192
Next Boot(in block sizes)
1 block = 128 entries
6
4
0
2
1
0
0
0
0
0
0
0
0
0
0
0
Next Boot(in block sizes)
1 block = 128 entries
6
4
0
2
|3
4
2
0
2
1
0
0
0
0
0
0
0
2
2
0
0
4
2
0
2
Content Addressable Memory (CAM)
|Allowed (64)
237