Test Cam Usage; View Cam-Acl Settings - Dell S4048–ON Configuration Manual

cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number l2qos
number l2pt number ipmacacl number vman-qos | vman-dual-qos number ecfmacl number
nlbcluster number ipv4pbr number openflow number | fcoe number iscsioptacl number
[vrfv4acl number]
NOTE: If you do not enter the allocation values for the CAM regions, the value is 0.
3. Execute write memory and verify that the new settings are written to the CAM on the next boot.
EXEC Privilege mode
show cam-acl
4. Reload the system.
EXEC Privilege mode
reload

Test CAM Usage

To determine whether sufficient CAM space is available to enable a service-policy, use the test-cam-usage command. To verify
the actual CAM space required, create a Class Map with all required ACL rules, then execute the test cam-usage command in
Privilege mode. The Status column in the command output indicates whether or not you can enable the policy.
Example of the test cam-usage Command
Dell#test cam-usage service-policy input test-cam-usage stack-unit 2 po 0
Stack-Unit| Portpipe|CAM Partition|Available CAM|Estimated CAM per Port|Status
------------------------------------------------------------------------------------
2 | 0
Dell#

View CAM-ACL Settings

The show cam-acl command shows the cam-acl setting that will be loaded after the next reload.
Example of Viewing CAM-ACL Settings
Dell(conf)#do show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
Ipv4Qos :
L2Qos :
L2PT :
IpMacAcl :
VmanQos :
VmanDualQos :
EcfmAcl :
FcoeAcl :
iscsiOptAcl :
ipv4pbr :
vrfv4Acl :
Openflow :
fedgovacl :
-- Stack unit 0 --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
|IPv4Flow |192
Next Boot(in block sizes)
1 block = 128 entries
6
4
0
2
1
0
0
0
0
0
0
0
0
0
0
0
Next Boot(in block sizes)
1 block = 128 entries
6
4
|3
4
2
0
2
1
0
0
0
0
0
0
0
2
2
0
0
4
2
Content Addressable Memory (CAM)
|Allowed (64)
227