Show Ip Ospf Area - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#show ip ospf vrf VPN-A
OSPF On VRF : VPN-A
Router ID : 100.1.1.1 (Auto selected)
State : Enabled
Default Information Originate:
State : Disabled
Always : Off
Metric : 1
OSPF Interface Settings
Interface IP Address
------------ ------------------ --------------- -------- --------- ---------
ip100 100.1.1.1/24
OSPF Area Settings
Area ID Type
--------------- ------ ----------------------- ----------------- ---------
0.0.0.0 Normal None
Virtual Interface Configuration
Transit Virtual
Area ID Neighbor Router Interval Interval
--------------- --------------- -------- -------- -------------- ------
OSPF Area Aggregation Settings
Area ID Aggregated
Network Address
--------------- ------------------ -------- ---------
OSPF Redistribution Settings
Source Destination
Protocol Protocol
-------- ------------
DXS-3600-32S#

40-25 show ip ospf area

This command is used to show general information about OSPF areas.
show ip ospf area [area-id] [vrf vrf-name]
Parameters
vrf vrf-name
area-id
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example show how to check the OSPF settings in the VRF VPN-A.
Area ID
0.0.0.0
Stub Import Summary LSA Stub Default Cost Translate
Hello Dead
LSDB
Type
Type Metric
-------- ------------ ------------
(Optional) Specifies to show area information about the OSPF VRF instance.
(Optional) Displays detailed information about the specified area.
None.
Privileged EXEC Mode.
Level: 3. (EI Mode Only Command)
State Link
Status
Disabled Link Up
None
Authentication Link
Advertise
RouteMapName
399
Metric
1
None
Status