D-Link DXS-3600-16S Manual page 209

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip dhcp relay option60 identifier "MSFT 5.0" relay 10.90.90.1
DXS-3600-32S(config)#
13-6 ip dhcp relay option60 default
This command is used to add default relay servers, used by the DHCP relay Option 60. The no form of this command
deletes the Option 60 default relay server.
ip dhcp relay option60 default relay ip-address
no ip dhcp relay option60 default
Parameters
ip-address
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip dhcp relay option60 default relay 10.90.90.90
DXS-3600-32S(config)#
13-7 show ip dhcp relay option60
This command is used to show the entries of the DHCP relay Option 60.
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
Global Configuration Mode.
Level: 8
This command configures the Option 60 relay rules. Note that different strings can
be specified with the same relay server and the same strings can be specified with
multiple relay servers.
A string map to a DHCP server has two modes: (1) One is exact-match and the (2)
other is partial-match. The exact-match is that the DHCP client string needs exactly
match the specified string. The partial-match is that the DHCP client string only
needs partially match the specified string.
You can verify your settings by entering the show ip dhcp relay option60
command.
This example shows how to add an Option 60 string "MSFT 5.0" relay entry to
10.90.90.1.
Specifies the IP address of the DHCP server.
None.
Global Configuration Mode.
Level: 8
When there is no matching server found for the packet, based on the Option 60
string, for the relay servers to use, it will be determined by the default relay server
setting.
You can verify your settings by entering the show ip dhcp relay option60
command.
This example shows how to add the default relay servers to use by the DHCP relay
Option 60.
201