D-Link DXS-3600-16S Manual page 358

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# interface vlan 10
DXS-3600-32S(config-if)# mpls ldp targeted-hello-accept
DXS-3600-32S(config-if)#
38-13 mpls ldp targeted-peer
This command is used to create a LDP targeted peer. Use the no form of this command to remove the previous
configured LDP targeted peer.
mpls ldp targeted-peer IP-ADDRESS
no mpls ldp targeted-peer IP-ADDRESS
Parameters
IP-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# mpls ldp targeted-peer 110.10.10.1
DXS-3600-32S(config-mpls-targeted-peer)#
38-14 targeted-hello
This command is used to set the hold-time or interval for the extended peer hello message. Use the no form of this
command to restore the default value.
targeted-hello {holdtime <seconds 15-65535> | interval <seconds 5-65535>}
no targeted-hello {holdtime | interval}
Parameters
holdtime <seconds 15-
65535>
interval <seconds 5-
65535>
Default
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This command only can be applied on a Layer 3 VLAN interface. If the targeted hello
message is acceptable, the interface will responds to received targeted hello
messages. Otherwise, if the received targeted hello is not coming from the local
configured targeted peer, the targeted hello message will be ignored.
This example shows how to configure the VLAN 10 interface to accept the targeted
hello message.
Specifies the LSR ID of the targeted peer.
No targeted peer.
Global Configuration Mode.
Level: 3.
This command is used to create a targeted peer and enter the MPLS targeted peer
configuration mode. The targeted peer specifies a potential indirectly connected
neighbor. The extended discovery will be used to discover the targeted peer.
This example shows how to create a targeted peer 110.10.10.1.
Specifies the hold-time of the hello message for the extended mechanism. This
value must be between 15 and 65535 seconds.
Specifies the interval of the hello message for the extended mechanism. This value
must be between 5 and 65535 seconds.
By default, the hold-time of the hello message for the extended mechanism is 45
seconds, and the interval of the hello message is 15 seconds, which is one third of
the hold-time.
350