Show Vlan Mapping - D-Link DXS-3600-16S Manual

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show dot1q-tunnel
dot1q Tunnel Interface:TGi1/0/1
Trust inner priority
VLAN mapping miss drop:Enabled
Insert dot1q tag
dot1q Tunnel Interface:TGi1/0/2
Trust inner priority
VLAN mapping miss drop:Disabled
DXS-3600-32S#
71-8 show frame-tag tpid
This command is used to display the outer TPID configuration.
show frame-tag tpid [interface INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show frame-tag tpid
Interface TPID
--------- -------
TGi1/0/3 0x8100
DXS-3600-32S#

71-9 show vlan mapping

This command is used to display the VLAN mapping configuration.
show vlan mapping [interface INTERFACE-ID [, | -]]
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
EXEC Mode.
Level: 3
This command is used to display the 802.1Q tunneling configuration on interfaces.
This example shows all 802.1Q tunnel port configurations.
:Enabled
:VLAN10
:Disabled
(Optional) Specifies the interfaces that will be displayed. If not specified, display the
outer TPID of all trunk ports.
None.
EXEC Mode.
Level: 3
This command is used to display the outer TPID configuration on trunk ports.
This example shows the outer TPID of trunk ports.
651