Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#forbidden vlan 1000
DXS-3600-32S(config-if)#
22-7 gvrp timer
This command is used to set the GVRP timer value on a port.
gvrp timer [join TIMER-VALUE | leave TIMER-VALUE | leave-all TIMER-VALUE]
Parameters
join
leave
leave-all
TIMER-VALUE
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#gvrp timer leave-all 500
DXS-3600-32S(config-if)#
22-8 show gvrp
This command is used to display the GVRP settings.
show gvrp [interface [INTERFACE-ID [,|-]]]
Parameters
interface
INTERFACE-ID
,
-
Default
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to set Ethernet port 1 as a forbidden port of VLAN 1000.
Specifies to set the timer for joining a group. The unit is in centiseconds.
Specifies to set the timer for leaving a group. The unit is in centiseconds.
Specifies to set the timer for leaving all groups. The unit is in centiseconds.
Specifies the timer value used here. This value must be between 1 and 65535. The
timer value in centiseconds.
Join: 20
Leave: 60
Leave-all: 1000
Interface Configuration Mode.
Level: 12
The value of these parameters must comply with the following rules:
1. LEAVE_TIMER >= 3 * JOIN_TIMER
2. LEAVE_ALL_TIMER > LEAVE_TIMER
This example shows how to set the leave-all timer to 500 centiseconds on Ethernet
port 3.
Displays the GVRP settings of the interface.
(Optional) Specifies the interface to display.
(Optional) Specifies a series of interfaces, or separate a range of interfaces from a
previous range.
(Optional) Specifies a range of interfaces.
None.
254