Traceroute Lsp - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#ping lsp 192.1.1.0/24
Ping 192.1.1.0/24
Reply from 192.1.1.1, time<10ms
Reply from 192.1.1.1, time<10ms
Reply from 192.1.1.1, time<10ms
Reply from 192.1.1.1, time<10ms
Ping Statistics for 192.1.1.0/24
Packets: Sent =4, Received =4, Lost =0
DXS-3600-32S#
Example
DXS-3600-32S#ping lsp 110.1.1.0/24
ping 110.1.1.0/24
Request time out
Request time out
Request time out
Request time out
Ping Statistics for 110.1.1.0/24
Packets: Sent =4, Received =0, Lost =4
DXS-3600-32S#

38-41 traceroute lsp

This command is used to initiate hop-by-hop fault localization as well as path tracing for LSP of a specified FEC.
traceroute lsp NETWORK-PREFIX/PREFIX-LENGTH [timeout SECONDS]
Parameters
NETWORK-PREFIX/
PREFIX-LENGTH
timeout SECONDS
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to check the connectivity of the LSP for network 192.1.1.0/
24.
This example shows how to check the connectivity of the LSP for network 110.1.1.0/
24.
Specifies the IPv4 prefix FEC used to check LSP connectivity.
Specifies the timeout interval in seconds for an MPLS request packet. The value
range is 1-99 seconds and the default value is 2 seconds.
None.
EXEC Mode.
Level: 3.
This command is used for hop-by-hop fault localization as well as path tracing LSP
of a specified FEC. The FEC can be an IP prefix.
If there is no LSP for the specified FEC, the "Destination unreachable" message will
be displayed. Otherwise, MPLS echo request messages will be sent out to along the
LSP of the specified FEC. The TTL in the outmost label of the MPLS echo requests
is set successively to 1, 2, 3, and so on. It forces the echo request, expired at each
successive LSR, along the LSP. The LSR returns an MPLS echo reply.
If the sender cannot receive reply before timeout, the traceroute will stop.
369