Ip Igmp Snooping Querier - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan 1
DXS-3600-32S(config-vlan)#no ip igmp snooping mrouter port-channel 1
DXS-3600-32S(config-vlan)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan 1
DXS-3600-32S(config-vlan)#ip igmp snooping mrouter forbidden port-channel 1
DXS-3600-32S(config-vlan)#
24-4 ip igmp snooping dyn-mr-aging-time
This command is used to configure the aging out time for dynamic multicast router interface. To restore the default
value, use the no form of this command.
ip igmp snooping dyn-mr-aging-time SECONDS
no ip igmp snooping dyn-mr-aging-time
Parameters
SECONDS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip igmp snooping dyn-mr-aging-time 100
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no ip igmp snooping dyn-mr-aging-time
DXS-3600-32S(config)#

24-5 ip igmp snooping querier

This command is used to enable the IGMP Snooping querier state. To disable the querier state, use the no form of this
command.
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to delete port-channel 1 from the static multicast router
interface in VLAN 1.
This example shows how to configure port-channel 1 as forbiddened multicast router
interface in VLAN 1.
Specifies the aging out time for dynamic router port, in second. The range is 10 to
65535.
300 seconds.
Global Configuration Mode.
Level: 8
When you enable IGMP Snooping, the switch will consider an interface connected to
a multicast router when receiving multicast packets which are PIM control
messages, DVMRP control messages or IGMP query messages with non-zero
source IP on that interface. This command is used to configure the aging out time of
these dynamically learned router interfaces.
To verify your configuration, use command show ip igmp snooping.
This example shows how to configure the aging out time of those dynamically
learned router interface to 100 seconds.
This example shows how to restore the default value of dynamic router interface
aging out time.
268