D-Link DXS-3600-16S Manual page 15

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#dot1x port-control force-unauthorized
DXS-3600-32S(config-if)#
2-3 dot1x pae authenticator
This command is used to configure a specific port as an IEEE 802.1X port access entity (PAE) authenticator. Use the
no form of this command to disable IEEE 802.1X authentication on the port.
dot1x pae authenticator
no dot1x pae
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#dot1x pae authenticator
DXS-3600-32S(config-if)#
2-4 dot1x control-direction
This command is used to configure the direction of the traffic on a controlled port as unidirectional (in) or bidirectional
(both). Use the no form of this command to reset the control direction of a port to its default value (both).
dot1x control-direction {both | in}
no dot1x control-direction
Parameters
both
in
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to deny all access to port 1.
None.
The 802.1X is disabled on a port by default.
Interface Configuration Mode.
Level: 8
You must also globally enable IEEE 802.1X authentication on the switch by using the
'dot1x system-auth-control' command.
This example shows how to configure port 1 as an IEEE 802.1X PAE authenticator.
Specifies to enable bidirectional control. Both incoming and outgoing traffic through
an IEEE 802.1X-enabled port are prevented if the port is not in the authorized state.
Specifies to enable unidirectional control. Incoming traffic through an IEEE 802.1X-
enabled port is prohibited if the port is not the authorized state.
The default is in bidirectional mode.
Interface Configuration Mode.
Level: 8
7