D-Link DXS-3600-16S Manual page 573

spanning-tree
no spanning-tree
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#spanning-tree
Success
DXS-3600-32S(config-if)#
57-15 spanning-tree hello-time
This command is used to configure the MSTP port hello time. Use the no form of this command to return the setting to
default setting.
spanning-tree hello-time SECONDS
no spanning-tree hello-time
Parameters
SECONDS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#spanning-tree hello-time 1
Success
DXS-3600-32S(config-if)#
57-16 spanning-tree externalcost
This command is used to configure the STP port external cost. Use the no form of this command to return the setting to
default setting.
spanning-tree externalcost COST
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
The value is disabled in default.
Interface Configuration Mode.
Level: 8
The spanning-tree/no spanning-tree command allows the Spanning Tree Protocol to
be enabled/disabled on the switch interface.
This example shows how to enable STP on an interface.
Specifies the time interval to send one BPDU at the Designated Port. The default
setting is 2 seconds. The range is 1 to 2 seconds.
The default value is 2.
Interface Configuration Mode.
Level: 8
The port hello time is only used in MSTP version. This parameter cannot be
configured in STP or RSTP version.
This example shows how to configure the port hello time.
565