D-Link DXS-3600-16S Manual page 310

30-3 speed
This command is used to set the speed at which the terminal transmits packets, execute the speed speed command in
the line configuration mode. To restore the speed to its default value, run the no speed command.
speed speed
no speed
Parameters
speed
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#line console
DXS-3600-32S(config-line)#speed 115200
DXS-3600-32S(config-line)#
30-4 show line
This command is used to show the configuration of a line.
show line {console | telnet | ssh}
Parameters
console
telnet
ssh
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show line console
Type: console
Speed: 115200
Timeout: 0 hour 10 min 0 sec
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the transmission rate (bps) on the terminal. For serial ports, the optional
rates are 9600, 19200, 38400, and 115200 bps. The default rate is 115200 bps.
The default rate is 115200.
Line Configuration Mode.
Level: 15
This command sets the speed at which the terminal transmits packets. It is only
applicable for serial ports.
This example shows how to configure the rate of the serial port to 115200 bps.
Displays the configuration of a console line.
Displays the configuration of a telnet line.
Displays the configuration of a telnet line.
None.
Privileged EXEC Mode.
Level: 15
This command shows the configuration information of a line.
This example shows the configuration of console port.
302