D-Link DXS-3600-16S Manual page 483

exceed-action
drop
dscp dscp-value
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#policy-map policy1
DXS-3600-32S(config-pmap)#class class1
DXS-3600-32S(config-pmap-c)#police rate 5000 4096 exceed-action dscp 23
DXS-3600-32S(config-pmap-c)#
48-11 policy-map
This command is used to create or modify a policy map that can be attached to multiple interfaces and to enter policy-
map configuration mode. To remove a existing policy map, use the no form of this command.
policy-map policy-map-name
no policy-map policy-map-name
Parameters
policy-map-name
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
(Optional) Specifies the action for the packets that exceeded the rate. The default
action is 'drop'.
Specifies to drop the packets exceeding the average rate.
Specifies to overwrite the DSCP value of the packets exceeding the average rate.
None.
Policy-map Class Configuration Mode.
Level: 15
Use this command to limit bandwidth of appointed flow and specify the method of
handling the excessive part.
If not specify exceed action, the default action 'drop' will be used.
In the policy-map class configuration mode, only one policer can be bind at one time.
This example shows how to configure the flow bandwidth.
Specifies the name of the policy map. The name can be a maximum of 32
alphanumeric characters.
None.
Global Configuration Mode.
Level: 15
475