Show Ip Interface - D-Link DXS-3600-16S Manual

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface out-band 1
DXS-3600-32S(config-if)#ip default-gateway 10.1.1.1
DXS-3600-32S(config-if)#

27-5 show ip interface

This command is used to display all the IP interfaces.
show ip interface [interface-name]
Parameters
interface-name
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip interface vlan2
IP Interface
VLAN Name
Interface Admin State
IP Directed Broadcast
IP MTU
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This command set or remove the default gateway address for the out-band interface.
This command is only valid for out-band IP interface.
Users can verify the settings by entering the show interface out-band and show ip
interface command.
This example shows how to set the default gateway to 10.1.1.1
(Optional) Specifies the IP interface's name. Use the interface type combined with
the interface number as the interface's name.
None.
Privileged Mode.
Level: 3
Use this command to display all the IP interfaces.
This example shows how to display the IP interface called 'vlan2'.
: vlan2
: VLAN0002
: Enabled
: Disabled
: 1500
289