D-Link DXS-3600-16S Manual page 587

59-3 username
This command is used to set a local username database for the purpose of authentication.
username name {{nopassword | password {password | encrypted encrypted-password}} | privilege privilege-
level}
no usename name
Parameters
name
nopassword
password {password |
encrypted encrypted-
password}
privilege privilege-level
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#username user password 12345
DXS-3600-32S(config)#
59-4 login local
This command is used to set the line login method.
login local
no login local
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#line console
DXS-3600-32S(config-line)#login local
DXS-3600-32S(config-line)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the name of the access database name.
Specifies to identify that no password will be set.
password - Specifies to identify the plain text password.
encrypted - Specifies to identify that the password entered is encrypted.
encrypted-password - Specifies to identify that the password entered is a encrypted
password. Consists out of 1-26 letters in upper/lower case and numerals. Leading
spaces are allowed but ignored. Spaces in between or at the end are regarded as
part of the password.
Specifies to identify the privilege level that will be entered when you use this
username to login. If not specified, the privilege level is 1.
By default, there is no username or password configured on this switch.
Global Configuration Mode.
Level: 15
This command is used to create a local user database for the purpose of
authentication.
This example shows how to create a username and password.
None.
By default, this option is disabled.
Line Configuration Mode.
Level: 15
When a user wants to use a username to enter the device on any line, we need to
set the login method as login local. If no username was created, the interface will
notify the user that no username is configured after which the switch will login
automatically without asking for a username and a password.
This example shows how to
579