D-Link DXS-3600-16S Manual page 525

Example
DXS-3600-32S#show ip rip
RIP Global State
Update Time
Timeout Time
Garbage Collection Time
RIP Interface Settings
Interface IP Address
------------- ------------------ ---------- ------------- ---------- -----
vlan1 10.90.90.90/8
Total Entries : 1
RIP Redistribution Settings
Source Destination
Protocol Protocol
-------- ------------
OSPF RIP
STATIC RIP
Total Entries : 2
DXS-3600-32S#
Example
DXS-3600-32S#show ip rip vrf VPN-A
VRF: VPN-A
RIP Global State
Update Time
Timeout Time
Garbage Collection Time
RIP Interface Settings
Interface IP Address
------------- ------------------ ---------- ------------- ---------- -----
ip100 100.1.1.1/24
Total Entries : 1
RIP Redistribution Settings
Source Destination
Protocol Protocol
-------- ------------
OSPF RIP
Total Entries : 1
DXS-3600-32S#
Display Parameters
RIP Global state
Update Time
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to display RIP information.
: Enabled
: 30 seconds
: 180 seconds
: 120 seconds
TX Mode
V1 Only
Type Metric
-------- ------------ ------------
All 2
All Transparency map1
This example shows how to check RIP information in VRF VPN-A.
: Enabled
: 40 seconds
: 120 seconds
: 120 seconds
TX Mode
V1 Only
Type Metric
-------- ------------ ------------
All Transparency
Description
The global administrative status of RIP. It is specified with the router rip command.
Rate (in seconds) at which update packets are sent. It is specified with the timers
basic command.
RX Mode Authen-
tication
V1 or V2 Disabled
RouteMapName
RX Mode Authen-
tication
V1 or V2 Disabled
RouteMapName
517
State
Disabled
State
Disabled