Route Map Commands - D-Link DXS-3600-16S Manual

Route Map Commands

53-1 route-map
This command is used to create or configure a route map or enter route map configuration mode. Use the no form of
this command to delete a route map or remove a clause of route map.
route-map MAP-NAME [permit | deny] [SEQUENCE-NUM]
no route-map MAP-NAME [permit | deny] [SEQUENCE-NUM]
Parameters
MAP-NAME
permit
deny
SEQUENCE-NUM
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#route-map rmap1 permit 10
DXS-3600-32S(config-route-map)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the name of route map. It can accept up to 16 characters. The syntax is
general string that does not allow space.
(Optional) Specifies a permit clause. If the match commands of one permit clause
are met, the route will be redistributed while the set commands of this clause may
modify the information of the route to be redistributed. If the match commands of one
permit clause are not met, the next clause of this route map will be tested.
(Optional) Specifies a deny clause. If the match commands of one deny clause are
met, the route will not be redistributed.
(Optional) Specifies the sequence number of clause. Each clause has a sequence
number, which indicates the position of the clause. The clause with lower sequence
number is preferred. The range is 1 to 65535.
The permit keyword is the default.
The default value of the sequence number of the first clause is 10.
Global Configuration Mode.
Level: 8
The route map can be used in route redistribution and route filtering. A route map
could be configured with multiple permit/deny clauses, which can have multiple
match or set commands.
The clause with lower sequence number has higher priority. If the route map clause
with low sequence number is not met, the next clause with higher sequence number
will be tested. If all clauses are not met, the test result is to deny (This means the
route map is ended with a implicit deny clause if this route map is not empty). If one
clause is met, next clauses will be skipped.
When one clause is tested, the logical AND algorithm is applied for multiple match
commands and the logical OR algorithm is applied for multiple objects within one
match command.
There is a limitation about sequence number. If the route map has been configured
with one clause, the sequence number must be specified when configure more
clauses for this route map.
If no argument is specified when use no route-map command, the route map is
deleted.
You can verify your settings by entering the show route-map command.
This example shows how to add one route map and enter the route map
configuration mode.
523