Show Clock - D-Link DXS-3600-16S Manual

Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#clock summer-time repeating 1 sun 4 2:00 last sun 10 2:00
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#clock summer-time date 12oct2011 2:00 26apr2012 2:00
DXS-3600-32S(config)#

56-8 show clock

This command is used to display the time and date from the system clock.
show clock [detail]
Parameters
detail
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show clock detail
Current Time Source
Boot Time
Current Time
Time Zone
Summer Time
Date
Offset In Minutes : 60
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Level: 8
In both the date and repeating forms of the command, the first part of the command
specifies when summer time begins, and the second part specifies when it ends. All
times are relative to the local time zone. The start time is relative to standard time.
The end time is relative to summer time. If the starting month is chronologically after
the ending month, the system assumes that you are in the southern hemisphere.
You can verify your settings by entering the show clock command.
This example shows how to specify that the summer time starts on the first Sunday
in April at 2 a.m. and ends on the last Sunday in October at 2 a.m.
This example shows how to specify the exact date and time. In the following
example, the daylight saving time (summer time) is configured to start on 2011
October 12 at 2 a.m., and end on 2012 April 26 at 2 a.m.
(Optional) Specifies the clock source (NTP, SNTP, hardware clock, and so on) and
the current summer-time setting (if any).
None.
Privileged EXEC Mode.
Level: 3
Use this command to show clock setting, time zone setting and summer time setting.
This example shows the output from the show clock command.
: System Clock
: 23 Dec 2011
: 23 Dec 2011
: UTC -08:00
: Date
From : 12 Oct 2011 02:00
To : 26 Apr 2012 02:00
05:40:42
06:56:25
555