D-Link DXS-3600-16S Manual page 19

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#dot1x initialize interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config)#
2-10 dot1x system-auth-control
This command is used to globally enable IEEE 802.1X authentication on the switch. Use the no form of this command
to disable IEEE 802.1X function.
dot1x system-auth-control
no dot1x system-auth-control
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#dot1x system-auth-control
DXS-3600-32S(config)#
2-11 dot1x system-max-user
This command is used to configure the maximum number of users that can be learned via 802.1X authentication. Use
the no form of this command to reset to the defaulting settings.
dot1x system-max-user <int 1-4096>
no dot1x system-max-user
Parameters
<int 1-4096>
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Under port-based mode, use the parameter interface <interface-id> to initialize a
specific port. Under host-based mode, use the parameter mac-address <mac-
address> to initialize a specific MAC address.
This example shows how to initialize the authenticator state machine on Ethernet
port 1.
None.
802.1X is disabled globally by default.
Global Configuration Mode.
Level: 8
Use this command to enable 802.1X authentication globally.
This example shows how to enable IEEE 802.1X authentication on the switch.
Specifies the maximum number of users.
By default, the maximum number of users that can be learned via 802.1X
authentication is 4096.
Global Configuration Mode.
Level: 8
The setting is a global limitation on the maximum number of users that can be
learned via 802.1X authentication. In addition to the global limitation, the maximum
number of users per port is also limited.
11