D-Link DXS-3600-16S Manual page 255

21-6 snmp trap mac-notification
This command is used to enable the MAC address notification function on interface. Use the no form of the command
to disable the function.
snmp trap mac-notification {added | removed}
no snmp trap mac-notification {added | removed}
Parameters
added
removed
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/2
DXS-3600-32S(config-if)#snmp trap mac-notification added removed
DXS-3600-32S(config-if)#
21-7 show mac-address-table aging-time
This command is used to display the aging time.
show mac-address-table aging-time
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show mac-address-table aging-time
Aging Time : 200 seconds.
DXS-3600-32S#
21-8 show mac-address-table notification
This command is used to display the MAC address notification configuration.
show mac-address-table notification [interface INTERFACE-ID | history]
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to enable the MAC notification trap when a MAC address is added on the
interface.
Specifies to enable the MAC notification trap when a MAC address is removed from
the interface.
By default, this option is disabled.
Interface Configuration Mode.
Level: 12
Used to configure the switch's MAC address table notification on interface.
This example shows how to enable MAC address notification on Ethernet interface
2.
None.
None.
EXEC Mode.
Level: 1
None.
This example shows how to display the aging time.
247