D-Link DXS-3600-16S Manual page 538

no-export
additive
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#route-map mapdampending permit 10
DXS-3600-32S(config-route-map)#set community 2:1
DXS-3600-32S(config-route-map)#
53-13 set dampening
This command is used to add a set command specify the dampening parameters of routes. Use the no form of this
command to delete this set command.
set dampening HALF-LIFE REUSE SUPPRESS MAX-SUPPRESS-TIME UN-REACHABILITY-HALF-LIFE
no set dampening
Parameters
HALF-LIFE
REUSE
SUPPRESS
MAX-SUPPRESS-TIME
UN-REACHABILITY-HALF-
LIFE
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
(Optional) Specifies routes not to be advertised outside of autonomous system
boundary.
(Optional) Specifies to add the community to the existed communities.
None.
Route Map Configuration Mode.
Level: 8. (EI Mode Only Command)
Use this command to modify the BGP community attribute. If additive is not
specified, the existing communities in the routes will be replaced.
You can verify your settings by entering the show route-map command.
This example shows how to add a set command to replace the BGP communities
attribute.
Specifies the time (in minutes) after which the penalty of the reachable routes is
decreased by half. The range is 1 to 45.
Specifies that if the penalty of a route is lower than this value, the route is
unsuppressed. The range is 1 to 20000.
Specifies that if the penalty of a route is higher than this value, the route is
suppressed. The range is 1 to 20000.
Specifies the maximum time (in minutes) a route can be suppressed. The range is 1
to 255.
Specifies the time (in minutes) after which the penalty of the unreachable routes is
decreased by half. The range is 1 to 45.
HALF-LIFE: 15 minutes.
REUSE: 750.
SUPPRESS: 2000.
MAX-SUPPRESS-TIME: 60 minutes
UN-REACHABILITY-HALF-LIFE: 15 minutes
Route Map Configuration Mode.
Level: 8
Use this command to modify the dampening parameters of routes when match
conditions are met.
You can verify your settings by entering the show route-map command.
530