D-Link DXS-3600-16S Manual page 119

Parameters
IP-ADDRESS
PEER-GROUP-NAME
MAP-NAME
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router bgp 100
DXS-3600-32S(config-router)#neighbor 172.16.10.10 unsuppress-map internal-map
DXS-3600-32S(config-router)#
7-61 neighbor update-source
This command is used to allow BGP sessions to use any operational interface for TCP connections. Use the no form of
this command to restore the interface assignment to the closest interface.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} update-source INTERFACE-TYPE INTERFACE-NUMBER
no neighbor {IP-ADDRESS | PEER-GROUP-NAME} update-source
Parameters
IP-ADDRESS
PEER-GROUP-NAME
INTERFACE-TYPE
INTERFACE-NUMBER
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the IP address of the BGP peer.
Specifies the name of a Border Gateway Protocol (BGP) peer group. The maximum
length is 16 characters.
Specifies the name of the route map. The length is up to 16 characters.
No routes are unsuppressed.
Router Configuration Mode.
Address Family Configuration Mode (IPv4 Unicast, VPNv4 and VRF).
Level: 8. (EI Mode Only Command)
When a route map is applied by this command, the suppressed route which matches
the permit rule will be unsuppressed.
If a route map is configured relating to a BGP neighbor but the route map doesn't
exist, it means deny any. If the route map exists but has no filter entry defined, it will
permit all.
Use the show ip bgp neighbors or show ip bgp peer-group command to verify
your settings.
This example shows the routes specified by a route map named internal-map being
unsuppressed for neighbor 172.16.10.10
Specifies the IP address of the BGP peer.
Specifies the name of a Border Gateway Protocol (BGP) peer group. The maximum
length is 16 characters.
Specifies the type of the interface. The supporting types include VLAN interface and
loopback interface.
Specifies the number of the interface. The interface number's range is from 1 to 8 for
loopback interface and from 1 to 4094 for VLAN interface.
By default, this option is disabled.
Router Configuration Mode.
Address Family Configuration Mode (VRF).
Level: 8. (EI Mode Only Command)
111