D-Link DXS-3600-16S Manual page 435

Command Default Level
Usage Guideline
Example
DXS-3600-32S#show module-info
Boot-UP Expansion Module (n)
Equipped Expansion Module (n)
1st port mode:40G
2nd port mode:40G
3rd port mode:4*10G
4th port mode:4*10G
4QXS Port Mode Configuration:
1st port mode:40G
2nd port mode:40G
3rd port mode:40G
4th port mode:40G
DXS-3600-32S#
43-12 port_mode
This command is used to configure the port mode of DXS-3600-EM-4QXS ports.
port_mode {[1st_port | 2nd_port | 3rd_port | 4th_port]} {4*10g | 40g}
Parameters
1st_port
2nd_port
3rd_port
4th_port
4*10g
40g
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S(config)#port_mode 1st_port 4*10g
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Level: 1
This command displays the hot swapping expansion module information.
This example show how to view the hot swapping expansion module information.
:DXS-3600-EM-4XT
:DXS-3600-EM-4QXS
Specifies to the configure the first port mode.
Specifies to the configure the second port mode.
Specifies to the configure the third port mode.
Specifies to the configure the fourth port mode.
Specifies to the configure the all the port modes.
Specifies to the configure the 40 Gigabit port mode.
None.
Configuration Mode.
Level: 15
This command configures the port mode to DXS-3600-EM-4QXS. This command
only works when executing the command copy configuration to flash when the
boot up module and current equipped module is DXS-3600-EM-4QXS.
This command configure the port mode of DXS-3600-EM-4QXS ports. The port
mode can be set as 40g port and 4*10G port.
427