Show Dot1X - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#dot1x system-fwd-pdu
DXS-3600-32S(config)#
2-14 dot1x port-fwd-pdu
This command used to control the forwarding of EAPOL PDUs on specific ports. Use the no form of this command to
reset to the defaulting settings.
dot1x port-fwd-pdu
no dot1x port-fwd-pdu
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#dot1x system-fwd-pdu
DXS-3600-32S(config)#end
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#no dot1x pae
DXS-3600-32S(config-if)#dot1x port-fwd-pdu
DXS-3600-32S(config-if)#

2-15 show dot1x

This command is used to display the IEEE 802.1X global configuration, interface configuration, authentication state,
statistics, diagnostics, and session statistics.
show dot1x [[interface INTERFACE-ID] {auth-configuration | auth-state | statistics | diagnostics | session-
statistics}]
Parameters
interface INTERFACE-ID
auth-configuration
auth-state
statistics
diagnostics
session-statistics
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to enable the forwarding of EAPOL PDUs, globally, on the
switch.
None.
802.1X can not forward EAPOL PDUs on all ports by default.
Interface Configuration Mode.
Level: 8
This is a per-port setting to control the forwarding of EAPOL PDUs. When 802.1X
functionality is disabled globally or for a port, and if 802.1X is set to forward EAPOL
PDUs both globally and for the port, a received EAPOL packet on the port will be
flooded in the same VLAN to those ports which have 802.1X forwarding EAPOL
PDUs and 802.1X is disabled (globally or just for the port). 802.1X can not forward
EAPOL PDUs on all ports by default.
This example shows how to enable the forwarding of EAPOL PDUs on port 1.
(Optional) Specifies a port to display authentication state, configuration, statistics,
diagnostics, or session statistics.
Displays the IEEE 802.1X interface configuration.
Displays the IEEE 802.1X authentication state.
Displays the IEEE 802.1X information about the authenticator statistics
Displays the IEEE 802.1X information about the authenticator diagnostics.
Displays the IEEE 802.1X information about the authenticator session statistics.
13