Ospf Show Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Command Mode
Privileged EXEC

OSPF Show Commands

7-183 show ip ospf
Display OSPF global configuration information for the specified virtual router. If no router is specified, it
displays information for the default router.
show ip ospf [vrf vrf-name]
Parameters
vrf vrf-name (Optional) Exit stub router mode of a virtual router.
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following shows example CLI display output for the command.
(Routing)#show ip ospf
Router ID....................................... 3.3.3.3
OSPF Admin Mode................................ Enable
RFC 1583 Compatibility......................... Enable
External LSDB Limit............................ No Limit
Exit Overflow Interval......................... 0
Spf Delay Time................................. 5 sec
Spf Hold Time.................................. 10 sec
Flood Pacing Interval.......................... 33 ms
LSA Refresh Group Pacing Time.................. 60 sec
Opaque capability.............................. Enable
AutoCost Ref BW................................ 100 Mbps
Default Passive Setting........................ Disabled
Prefix Suppression............................. Disabled
Maximum Paths.................................. 48
Maximum Routes................................. 8160
Default Metric................................. Not configured
Stub Router Configuration...................... None
Summary LSA Metric Override.................... Disabled
BFD Enabled.................................... NO
767