Time Range Commands - D-Link DXS-3600-16S Manual

Time Range Commands

63-1 time-range
This command is used to enter the Time Range configuration mode in the global configuration mode. To delete a time
range, use the no to form of this command.
time-range <range_name 32>
no time-range <range_name 32>
Parameters
range_name 32
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#time-range a
DXS-3600-32S(config-time-range)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no time-range a
Success
DXS-3600-32S(config)#
63-2 periodic
This command is used to configure the time range.
periodic <daylist> HH:MM to HH:MM
Parameters
daylist
HH:MM
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the time range name string in the range of 1 to 32.
None.
Global Configuration Mode.
Level: 8
In the time range configuration mode, the time range can be configured periodically.
Use the no time-range command to delete the time range. If the time range is
binded to an ACL profile or a PoE port (if PoE is supported), the deletion will fail.
This example shows how to enter time range configure mode.
This example shows how to delete a time range.
Specifies the day list string used. Options to choose from are sun, mon, tue, wen,
thu, fri and sat.
Specifies the start or end time used. The range is from 00:00 to 23:59.
The maximum number of the time range is 64.
Time Range Configuration Mode.
Level: 8
This command configures the time range. If the time range already exists, this
command will modify the configuration. If not, this command will add a time range.
To verify your configuration, use show time-range.
597