D-Link DXS-3600-16S Manual page 148

Example
(Continued)
BGP neighbor: 10.5.5.5 (External Peer), vrf VPN-A
-------------------------------------------------------------------
Session State
Remote AS
Remote Router ID
BGP State
Hold Time
Keepalive Interval
Advertisement Interval
EBGP Multihop
Weight
Address Family IPv4 Unicast
IPv4 Unicast
AS Override
Next Hop Self
Remove Private As
AllowAS In
Soft Reconfiguration Inbound
Send Community
Default Originate
Outbound Route Filter (ORF) type (64) Prefix list:
Send Mode
Receive Mode
Prefix Max Count
Prefix Warning Threshold
Prefix Warning Only
Total neighbor number : 2
DXS-3600-32S#
Display Parameters
BGP neighbor
Internal Peer
External Peer
Session State
Remote AS
Remote Router ID
BGP State
UP for
Hold Time
Keepalive Interval
Advertisement Interval
EBGP Multihop
Weight
Update Source
loopback
vlan
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to display all the neighbors.
Description
IP address of the BGP neighbor.
Indicates that the neighbor is internal.
Indicates that the neighbor is external.
Indicates whether the neighbor is shut down or not.
AS number of the neighbor.
The router identifier of the local BGP router.
The Finite State Machine (FSM) of the neighbor. The value may be Idle, Connect,
Active, Opensent, Openconfirm and Established.
Indicates how long the Established state last. This field only display in the
Established state.
Indicates the maximum number of seconds that may elapse between the receipts of
successive KEEPALIVE and/or UPDATE messages with the neighbor.
Indicates the number of seconds between sending KEEPALIVE message with the
neighbor.
Indicates the minimum interval between sending Border Gateway Protocol (BGP)
routing updates.
Indicates the TTL of the BGP packet sent to the neighbor.
Indicates the weight that will be associated to the routes learned from the neighbor.
Interface used for TCP connection with the neighbor.
Indicates that the update source interface is a loopback interface, followed by its
number.
Indicates that the update source interface is a VLAN interface, followed by its VLAN
ID.
: Enabled
: 2
: 0.0.0.0
: Idle
: 180 Seconds
: 60 Seconds
: 30 Seconds
: 1
: 0
: None
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: None
: Disabled
: Disabled
: Disabled
: 12000
: 75
: Disabled
140