D-Link DXS-3600-16S Manual page 277

ip igmp snooping querier
no ip igmp snooping querier
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan 1
DXS-3600-32S(config-vlan)#ip igmp snooping querier
DXS-3600-32S(config-vlan)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan 1
DXS-3600-32S(config-vlan)#no ip igmp snooping querier
DXS-3600-32S(config-vlan)#
24-6 ip igmp snooping static-group
This command is used to directly add an interface list or a port-group to a multicast group. Use the no form of this
command to remove the setting.
ip igmp snooping static-group GROUP-ADDRESS {interface INTERFACE-TYPE INTERFACE-ID [, | -] | group-
channel GROUP-ID}
no ip igmp snooping static-group GROUP-ADDRESS {interface INTERFACE-TYPE INTERFACE-ID [, | -] |
group-channel GROUP-ID}
Parameters
GROUP-ADDRESS
INTERFACE-TYPE
INTERFACE-ID
,
-
GROUP-ID
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
By default, this option is disabled.
Interface Configuration Mode.
Level: 8
This command is used to enable the IGMP Snooping querier state. Note that if IGMP
is enabled, IGMP Snooping querier will be automatically disabled on the interface.
To verify your configuration, you can use show ip igmp snooping querier.
This example shows how to enable IGMP Snooping querier state on VLAN 1.
This example shows how to disable IGMP Snooping querier state on VLAN 1.
Specifies the address of the multicast group. This is a multicast IP address in four-
part dotted-decimal notation.
Specifies the interface type. The only possible valid value is tenGigabitEthernet.
Specifies the port number.
Specifies a series of ports, or separate a range of ports from a previous range. No
space before and after the comma.
Specifies a range of ports. No space before and after the hyphen.
Specifies the port-channel number.
No any static group is configured.
Interface Configuration Mode.
Level: 8
269