D-Link DXS-3600-16S Manual page 356

Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# snmp-server enable traps mpls ldp
DXS-3600-32S(config)#
38-9 mpls label protocol ldp (interface configuration)
This command is used to enable LDP on this interface. Use the no mpls label protocol command in interface
configuration mode to disable LDP on this interface.
mpls label protocol ldp
no mpls label protocol
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# interface vlan 10
DXS-3600-32S(config-if)# mpls label protocol ldp
DXS-3600-32S(config-if)#
38-10 mpls ldp hello-holdtime
This command is used to configure the LDP link hello hold-time for the interface. Use the no form of this command to
restore the default value.
mpls ldp hello-holdtime SECONDS
no mpls ldp hello-holdtime
Parameters
SECONDS
Default
Command Mode
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
Disabled.
Global Configuration Mode.
Level: 12.
This command used to configure the LDP trap state.
This example shows how to enable the LDP trap state.
None.
Disabled.
Interface Configuration Mode.
Level: 15.
This command only can be applied on a Layer 3 VLAN interface. Use the mpls label
protocol ldp command in the interface configuration mode to enable LDP on this
interface.
LDP is running on an interface only when:
• MPLS and LDP are globally enabled.
• MPLS and LDP are enabled on this interface.
This example shows how to enable LDP on interface VLAN 10.
Specifies the link hello hold-time in seconds. The range is 5-65535 seconds.
15 seconds.
Interface Configuration Mode.
348