D-Link DXS-3600-16S Manual page 215

Usage Guideline
Example
DXS-3600-32S#clear ip dhcp conflict *
DXS-3600-32S#
14-4 default-router
This command is used to define the default gateway of the DHCP client in the DHPC address pool configuration mode.
The no form of this command can be used to delete the definition of the default gateway.
default-router ip-address [ip-address2 [ip-address3]]
no default-router
Parameters
ip-address
ip-address2 ip-address3
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip dhcp pool pool1
DXS-3600-32S(dhcp-config)#default-router 192.168.12.1
DXS-3600-32S(dhcp-config)#
14-5 dns-server
This command is used to define the DNS server of the DHCP client in the DHPC address pool configuration mode. The
no form of this command can be used to delete the definition of the DNS server.
dns-server ip-address [ip-address2 [ip-address3]]
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
The DHCP server uses the ping session to detect the address conflict, while the
DHCP client uses the address resolution protocol (ARP) to detect the address
conflict. The clear ip dhcp conflict command can be used to delete the history
conflict record.
Note the following behavior for the clear ip dhcp conflict command:
• If you do not specify the VRF name option and an IP address is specified, it is
assumed that the IP address is an address in the global address space and
will look among all the nonvirtual VRF DHCP pools for the specified conflict.
• If you do not specify the VRF name option and the * option is specified, it is
assumed that all automatic or on-demand conflicts in all VRF and non-VRF
pools are to be deleted.
• If you specify both the VRF name option and the * option, all automatic or on-
demand conflicts in the specified pool only will be cleared.
• If you specify the VRF name option and an IP address, the specified conflict will
be deleted from the specified pool.
This example shows how to clear all address conflict records.
Specifies to define the IP address of the equipment. It is required to configure one IP
address at least.
(Optional) Up to 3 gateways can be configured.
No gateway is defined by default.
DHCP Address Pool Configuration Mode.
Level: 8
In general, the DHCP client should get the information of the default gateway from
the DHCP server. The DHCP server should specify one gateway address for the
client at least, and this address should be of the same network segment as the
address assigned to the client.
This example shows how to define 192.168.12.1 as the default gateway.
207