Filter Database (Fdb) Commands - D-Link DXS-3600-16S Manual

Filter Database (FDB) Commands

21-1 mac-address-table aging-time
This command is used to set the length of time that a dynamic entry remains in the MAC address table. Use the no
form of the command to set the time to default.
mac-address-table aging-time SECONDS
no mac-address-table aging-time
Parameters
SECONDS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#mac-address-table aging-time 200
DXS-3600-32S(config)#
21-2 clear mac-address-table
This command is used to delete a specific dynamic, filtering or static MAC address, all dynamic or static MAC
addresses on a particular interface, all dynamic, filtering or static MAC addresses on a particular VLAN or all dynamic,
filtering or static MAC addresses from the MAC address table.
clear mac-address-table dynamic [address MAC-ADDR | interface INTERFACE-ID | vlan VLAN-ID]
clear mac-address-table filtering [address MAC-ADDR | vlan VLAN-ID]
clear mac-address-table static [address MAC-ADDR | interface INTERFACE-ID | vlan VLAN-ID]
Parameters
dynamic
filtering
static
address MAC-ADDR
interface INTERFACE-ID
vlan VLAN-ID
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the aging time in seconds. The valid range is 0 or 10 to 1000000 seconds.
0 means that the aging function is disabled.
The default is 300 seconds.
Global Configuration Mode.
Level: 12
Set the aging-time to 0 to disable the MAC address table aging out function.
This example shows how to set the aging time to 200 seconds.
Deletes the specified dynamic MAC address.
Deletes the specified filtering MAC address.
Deletes the specified static MAC address.
Specifies the MAC address.
Specifies the interface that the MAC address will be deleted from. The specified
interface can be a physical port or a port-channel
Specifies the VLAN ID. The valid values are from 1 to 4094.
None.
Privileged EXEC Mode.
Level: 12
The clear mac address-table command only clears dynamic, filtering or static MAC
address entries.
243