Virtual Lan (Vlan) Commands - D-Link DXS-3600-16S Manual

Virtual LAN (VLAN) Commands

66-1 vlan
This command is used to create VLANs and enter the VLAN configuration mode. Use the no vlan configuration
command to remove VLANs.
vlan VLAN-ID [, | -]
no vlan VLAN-ID [, | -]
Parameters
VLAN-ID
,
-
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the ID of the VLAN to be created, removed or configured. The valid VLAN
ID range is from 1 to 4094. The default VLAN with VLAN ID 1 can not be removed.
Specifies a series of VLANs, or separate a range of VLANs from a previous range.
No space is required before and after the comma.
(Optional) Specifies a range of VLANs. No space is required before and after the
hyphen.
VLAN ID 1 exists in the system as the default VLAN.
Global Configuration Mode.
Level: 12
This command can be used to create VLANs. Entering the vlan command with a
VLAN ID enters VLAN configuration mode. Entering the VLAN ID of an existing
VLAN does not create a new VLAN, but allows the user to modify VLAN parameters
for the specified VLAN. When the user enters the VLAN ID of a new VLAN, the
VLAN will be automatically created. If the new VLAN is a port allowed VLAN, the port
will join to the new VLAN automatically.
The user can use the no vlan command to remove VLANs. The default VLAN
cannot be removed. The dynamic VLAN that is created through GVRP cannot be
removed through this command. If the VLAN is used as ERPS R-APS VLAN,
RSPAN VLAN, voice VLAN, subnet VLAN or MAC-based VLAN, it cannot be
removed too.
Removing VLAN doesn't remove the association of the VLAN with its static member
ports. Once the VLAN is re-created, these ports will join into it automatically.
The learned dynamic FDB entries in the removed VLAN will be cleared. The static
FDB entries in this VLAN will not be removed.
If the removed VLAN is a private VLAN, the configuration for the private VLAN will be
cleared.
If the removed VLAN is a port's access VLAN, the port's access VLAN will be reset
to VLAN 1.
If the VLAN is used as protocol VLAN or VLAN translation, removing it doesn't affect
the VLAN assignment.
If the VLAN is used as super VLAN or L3 interface, removing it will lead to these
functions become unavailable until this VLAN is re-created.
603