Upgrade And Maintenance Commands - D-Link DXS-3600-16S Manual

Upgrade and Maintenance Commands

65-1 copy
This command is used to upgrade and maintain the switch by use of the TFTP protocol for uploads and downloads.
copy flash: filename tftp://location/filename
copy tftp://location/filename flash: filename
Parameters
filename
//location/filename
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#copy tftp: //192.168.0.27/firmware.had flash: run.had
Address of remote host [192.168.0.27]
Source filename [firmware.had]
Destination filename [run.had]
Accessing tftp://192.168.0.27/ firmware.had...
Transmission start...
Transmission finished, file length 5156864 bytes.
Please wait, programming flash... Done
DXS-3600-32S#
Example
DXS-3600-32S#copy flash: run.had tftp: //192.168.0.27/firmware.had
Source filename [run.had]
Address of remote host [192.168.0.27]
Destination filename [firmware.had]
Accessing tftp://192.168.0.27/firmware.had...
Transmission start...
Transmission finished, file length 5156864 bytes.
DXS-3600-32S#
65-2 boot system
This command is used to configure the specific firmware as the boot up image.
boot system flash filename
Parameters
filename
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the file name used.
Specifies the file's location or the server IP address.
None.
Privileged EXEC Mode.
Level: 15
If the file is transmitted successfully, show the length of the transmitted file.
Otherwise, show the failure information. Only configuration and firmware files can be
transmitted by TFTP.
This example shows how to download a firmware named "firmware.had" from a
TFTP server.
This example shows how to upload a firmware to a TFTP server.
Specifies the file name used.
601