D-Link DXS-3600-16S Manual page 485

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#priority-queue cos-map 2 3 5 6
DXS-3600-32S(config)#
48-13 queue bandwidth
This command is used to specify or modify the bandwidth allocated for a CoS. To remove the bandwidth allocated for a
CoS, use the no form of this command.
queue queue-id bandwidth min max
no queue queue-id bandwidth
Parameters
queue-id
min
max
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
CoS -> queue:
0 -> 2
1 -> 0
2 -> 1
3 -> 3
4 -> 4
5 -> 5
6 -> 6
7 -> 7
Global Configuration Mode.
Level: 15
The priority-queue cos-map command use to configure the CoS to queue map
table. When a packet is received, the packet will be given an internal CoS. This
internal CoS is used to select the transmit queue based on the CoS to queue map
table. The CoS queue with higher number owned with higher priority.
This example shows how to assign the CoS priority 3,5,6 to CoS queue 2.
Specifies the CoS queue to assign bandwidth.
Specifies the minimal guaranteed bandwidth in Kbps allocated to a specified COS.
Specifies the maximum bandwidth in Kbps for a specified COS.
No limitation.
Interface Configuration Mode.
Level: 15
Only physical ports are valid for this command.
When the minimal bandwidth is configured, the packet transmitted from the queue
can be guaranteed even though the link is congested.
When the maximum bandwidth is configured, packets transmitted from the queue
cannot exceed the maximum bandwidth even if the bandwidth is available.
Note that the configuration of queue bandwidth can only be attached to a physical
port but not a port-channel. That is the bandwidth of one CoS cannot be summation
across physical ports.
477