D-Link DXS-3600-16S Manual page 45

Command Default Level
Usage Guideline
Example
DXS-3600-32S(config)# vlan access-map vlan-map 20
DXS-3600-32S(config-access-map)# match ip address 10 20 sp1 30 sp2
DXS-3600-32S(config-access-map)# end
DXS-3600-32S# show vlan access-map
VLAN access-map vlan-map 20
match ip address:
action: forward
DXS-3600-32S# configure terminal
DXS-3600-32S(config)# vlan access-map vlan-map 30
DXS-3600-32S(config-access-map)# match mac address 6710 6720 ext_mac 7760
DXS-3600-32S(config-access-map)# end
DXS-3600-32S# show vlan access-map
VLAN access-map vlan-map 20
match ip address: 10,20,sp1,30,sp2
action: forward
VLAN access-map vlan-map 30
match mac address: 6710,6720,ext_mac,7760
action: forward
DXS-3600-32S#
3-25 action
This command is used to set the forwarding, drop, and redirect actions of submaps in the VACL mode. Use the no
command to return to the default configuration.
action forward
no action forward
action drop
no action drop
action redirect {port_id}
no action redirect {port_id}
Parameters
port_id
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Level: 12
One submap can only be associated with an IP ACL or a MAC ACL. You can not
associate a submap with both an IP ACL and a MAC ACL.
One submap can only be associated with at most 8 ACLs.
One submap can not be associated with an non-existent ACL.
One submap can not be associated with an ACL, which is NULL ACL.
This example shows how to configure matching content in the submap.
10,20,sp1,30,sp2
Specifies the redirection port used.
Default action is forward.
Access-map Configuration Mode.
Level: 12
One submap has only one action.
The submap action is applied to all the associated ACLs.
37