D-Link DXS-3600-16S Manual page 161

Display Parameters
BGP Peer Group
Description
Session State
Remote AS
Not Set (remote AS)
Advertisement Interval
Keepalive Interval
Hold Time
EBGP Multihop
Weight
Update Source
loopback
vlan
Password
Address Family IPv4 Unicast Indicates that the configuration below is only for IPv4 unicast address family.
Address Family VPNv4
Unicast
Members
AS Override
Site-of-Origin
Next Hop Self
Route Reflector Client
Send Community
Standard (send community)
Extended (send community) The local BGP send extended community attributes to the neighbor.
None (send community)
Remove Private As
AllowAS In
Num (AllowAS in)
Soft Reconfiguration
Inbound
Unsuppressed Route Map
Default Originate
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Description
Name of the peer group.
Show the description configured to describe the peer group
Indicates whether the peer group is shut down or not.
Remote AS number of the peer group.
Indicates that this peer group doesn't assign any AS number.
Indicates the minimum interval between sending Border Gateway Protocol (BGP)
routing updates.
Indicates the number of seconds between sending KEEPALIVE message with the
members of this peer group.
Indicates the maximum number of seconds that may elapse between the receipts of
successive KEEPALIVE and/or UPDATE messages with the members of this peer
group.
Indicates the TTL of the BGP packet sent to the members of this peer group.
Indicates the weight that will be associated to the routes learned from the members
of this peer group.
Interface used for TCP connection with the neighbor.
Indicates that the update source interface is a loopback interface, followed by its
number.
Indicates that the update source interface is a VLAN interface, followed by VLAN ID.
Show the password set on the TCP connection to the members of this peer group.
Indicates that the configuration below is only for VPNv4 unicast address family.
Members of this peer group, separated by comma.
Indicates whether the local BGP override the AS number of the peer with its own AS
number in the routes received from the members of the peer group.
Indicates the Site-of-Origin value configured to the members of the peer group.
Indicates whether the local BGP enable the router as the next hop for the members
of this peer group.
Indicates whether this peer group is a route reflector client of the local BGP.
Indicates whether the local BGP send its community attributes to the members of
this group.
The local BGP send standard community attributes to the neighbor.
The local BGP doesn't send any community attributes to the neighbor.
Indicates whether the configuration of removing the private AS from the AS path
attribute in the updates sent to the members of this peer group is enabled or not.
Indicates whether the local BGP allow its own AS number appearing in the received
BGP update packets form the members of this peer group.
Indicates how many times that the local BGP allow its own AS number appearing in
the received BGP update packets from the members of this peer group. This field is
only display when the AllowAS In is enabled.
Indicates whether the local BGP store the route updates received from members of
this peer group.
Indicates a route map name which the routes previously suppressed by the
aggregate-address command must be applied.
Indicates whether the local BGP send the default route to the members of this peer
group.
153