Dhcp Server Commands - D-Link DXS-3600-16S Manual

DHCP Server Commands

14-1 bootfile
This command is used to define the startup mapping file name of the DHCP client in the DHCP address pool
configuration mode. The no form of this command can be used to remove the definition.
bootfile file-name
no bootfile
Parameters
file-name
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip dhcp pool pool1
DXS-3600-32S(dhcp-config)#bootfile device.conf
DXS-3600-32S(dhcp-config)#
14-2 clear ip dhcp binding
This command is used to clear the DHCP binding table.
clear ip dhcp binding [vrf vrf-name] {* | ip-address}
Parameters
vrf vrf-name
*
ip-address
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the startup file name.
No startup file name is defined, by default.
DHCP Address Pool Configuration Mode.
Level: 8
Some DHCP clients need to download the operating system and the configuration
file during the startup. The DHCP server should provide the mapping file name
required for the startup, so that DHCP clients can download the file from the
corresponding server (such as TFTP). The servers are defined by the next-server
command.
This example shows how to define the 'device.conf' file as the startup file name.
(Optional) Specifies to clear virtual routing and forwarding (VRF) information from
the DHCP database.
Specifies to delete all DHCP bindings.
Specifies to delete the binding of the specified IP addresses.
None.
Privileged Mode.
Level: 2
205