Save Log - D-Link DXS-3600-16S Manual

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#logging buffered write-delay infinite
DXS-3600-32S(config)#

60-12 save log

This command is used to save the log.
save log
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#save log
Saving all system logs to NV-RAM............. Done.
DXS-3600-32S(config)#
1 2011-12-23 17:35:27 INFO(6) System log saved to flash by console (Username
: Anonymous)
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
The memory buffer for the log is used in a recycled manner. That is, when it is full,
the oldest information will be overwritten. The content of the logging buffer will be
saved to the FLASH periodically if the interval time is specified, so the message can
be restored on reboot. To show the log information in the memory buffer, run show
logging at the privileged user level.
As lower values indicate higher levels, level 0 indicates the information of the highest
level. When the level of log information to be displayed on a specified device, the log
information is at or below the set level will not be displayed.
This example shows how to disable record logs into flash.
None.
None.
Global Configuration Mode.
Level: 15
As log entries are created and store in the DRAM, a log message may be lost while
powering down the switch. To avoid the loss of log entries, the administrator needs
save the log into the NVRAM via UI or use the periodical save command to save the
log to the NVRAM.
This example shows the command of save log.
590