D-Link DXS-3600-16S Manual page 160

Display Parameters
Fast External Fallover
Aggregate Next Hop Check
7-88 show ip bgp peer-group
This command is used to display information of the BGP peer group.
show ip bgp peer-group [{[vrf VRF-NAME] [PEER-GROUP-NAME] | all}]
Parameters
vrf VRF-NAME
PEER-GROUP-NAME
all
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip bgp peer-group mygroup
BGP Peer Group : mygroup
-----------------------------------------------------------------------
Description
Session State
Remote AS
Advertisement Interval
Keepalive Interval
Holdtime Interval
EBGP Multihop
Weight
Address Family IPv4 Unicast
Members
Route Reflector Client
Send Community
Remove Private As
Next Hop Self
AllowAS In
Soft Reconfiguration Inbound
Default Originate
Outbound Route Filter (ORF) type (64) Prefix list:
Send Mode
Receive Mode
Prefix Max Count
Prefix Warning Threshold
Prefix Warning Only
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Description
If enable, Border Gateway Protocol (BGP) routing process will immediately reset its
external BGP peer sessions if the link used to reach these peers goes down.
Only the routes with the same next hop attribute can be aggregated if the BGP
aggregate next hop check is enabled.
(Optional) Specifies the VRF name. The length of the VRF-NAME is 12 characters.
Specifies the name of a Border Gateway Protocol (BGP) peer group. The maximum
length is 16 characters.
(Optional) Displays information of all BGP peer groups.
None.
Privileged Mode.
Level: 3. (EI Mode Only Command)
Use this command to display the contents of the BGP peer group.
This example shows how to display the information of the peer group named
'mygroup'.
:
: Enabled
: Not Set
: 30 seconds
: 60ds
: 180 seconds
: 1
: 0
: None
: Disabled
: None
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: 16000
: 75
: Disabled
152