D-Link DXS-3600-16S Manual page 613

dot1q-tunnel
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#switchport mode trunk
DXS-3600-32S(config-if)#
66-4 switchport access vlan
This command is used to specify the access VLAN for the interface. Use no switchport access vlan interface
command to reset to default setting.
switchport access vlan VLAN-ID
no switchport access vlan
Parameters
VLAN-ID
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the port as a dot1q-tunnel port.
Access mode.
Interface Configuration Mode.
Level: 12
The valid interfaces for this command are physical ports or link aggregation groups.
When the port changes the VLAN mode, the VLAN membership setting related to
the previous mode will be lost. The PVID is set to default value too. If setting the port
mode to access or dot1q tunnel, the GVRP status of the port will be disabled.
The user can specify the access VLAN for an access port. On an access port, only
untagged packets are processed, they are transmitted and received on the access
VLAN. The user can specify multiple VLANs for a trunk port. Packets on a trunk port
are received and transmitted on trunk VLANs in tagged form. The user can specify
multiple VLANs for a hybrid port. Packets on a hybrid can be received and
transmitted in tagged form or untagged form.
Creating a link aggregation doesn't need the VLAN setting of its member ports are
same as. The VLAN setting of the new link aggregation is default value. The VLAN
setting of member ports become inactive. Once a member port is removed from the
link aggregation group, its VLAN setting becomes active again.
This example shows how to set an interface port 1 as a trunk port.
Specifies the access VLAN for the interface.
VLAN 1.
Interface Configuration Mode.
Level: 12
The command can only be configured on physical ports or link aggregation groups
that are set to access mode or dot1q-tunnel mode.
This command sets the access VLAN for an access port. The port becomes an
untagged member of access VLAN and the port's PVID will also be changed to the
access VLAN. If the specified access VLAN does not exist, it will be created
automatically. Only one access VLAN can be specified. The succeeding command
overwrites the previous command.
605