D-Link DXS-3600-16S Manual page 434

status
switchport
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show interface tenGigabitEthernet 1/0/1
TenGigabitEthernet
Description
AdminStatus
OperStatus
Hardware
MTU
PhysAddress
AdminDuplex
OperDuplex
AdminSpeed
OperSpeed
FlowControlAdminStatus: Enabled
FlowControlOperStatus : Link Down
Link Trap Status
DXS-3600-32S#
Example
DXS-3600-32S#show interface tenGigabitEthernet 1/0/1 description
Interface Status
--------- -------- -------------- ---------------------------------
TGi1/0/1 Disabled Enabled
DXS-3600-32S#
Example
DXS-3600-32S#show interface tenGigabitEthernet 1/0/1 switchport
Interface State/
MDIX
--------- -------------- --------------------- --------------------- --------
TGi1/0/1 Enabled/Auto
DXS-3600-32S#
43-11 show module-info
This command is used to dispay hot swapping expansion module information.
show module-info
Parameters
Default
Command Mode
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specfies the display the interface status.
Specifies to display Layer 2 interface information.
None.
Global Configuration Mode.
Level: 1
Use this command to show the interface information.
This example shows how to display interface information of the 10G interface for port
1.
: 1/0/1
:
: Enabled
: Disabled
: 10GBASE-R
: 1536
: 00-01-02-03-05-00
: Full
: Link Down
: 10G
: Link Down
: Disabled
This example shows how to display the interface description of port 1.
Administrative Description
This example shows how to display switchport information of port 1.
Settings
Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
10G/Full/Enabled
None.
None.
Global Configuration Mode.
Connection
Link Down
426
Address
Enabled