D-Link DXS-3600-16S Manual page 454

show ip ecmp load-balance
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip ecmp load-balance
ECMP Load Balance Algorithm :
Destination IP : used.
Source IP : used.
CRC_Low : not used.
CRC_High : not used.
TCP_UDP_Port : used.
DXS-3600-32S#
46-9 show ip route
This command is used to display the current state of the IP routing table.
show ip route [vrf vrf-name] [network [net-mask]] [{count | connected | static | rip | ospf | bgp | weight}]
Parameters
vrf vrf-name
network
net-mask
count
connected
static
rip
ospf
bgp
weight
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
None.
Privileged EXEC Mode.
Level: 3
Use this command to check the load-balancing algorithm settings.
This example shows how to check the load-balancing algorithm settings.
(Optional) Specifies to show routes of one VRF.
(Optional) Specify the destination IP address of the route want to be displayed. If net-
mask is not specified, the longest prefix matched route will be displayed.
(Optional) Specify the destination netmask of the route want to be displayed.
(Optional) Specifies to show the number of active route.
(Optional) Specifies to show only connected routes.
(Optional) Specifies to show only static routes. One static route may be active or
inactive.
(Optional) Specifies to show only RIP routes.
(Optional) Specifies to show only OSPF routes.
(Optional) Specifies to show only BGP routes.
(Optional) Specifies to show only multipath static routes.
None.
Privileged EXEC Mode.
Level: 3
Use the command with keyword count means to show the number of active routes,
active route is the route which had been written into chip and can forward traffic.
User can specify the network as an IP address or a network address. They both are
the same in this implementation. If net-mask is not specified, the longest prefix
matched route will be displayed. If net-mask is specified, only the destination routes
matched the specified network will be displayed
446