D-Link DXS-3600-16S Manual page 367

Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show mpls
MPLS Status : Enabled
LSP Trap Status: Disabled
DXS-3600-32S#
38-29 show mpls interface
This command is used to display MPLS enabled interfaces.
show mpls interface [INTERFACE-ID]
Parameters
INTERFACE-ID
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show mpls interface
Interface IP Address
--------- -------------
VLAN 10 10.90.90.1/24
VLAN 20 172.18.1.1/24
Total Entries: 2
DXS-3600-32S#
38-30 show mpls forwarding-table
This command is used to display the MPLS label forwarding path information.
show mpls forwarding-table [NETWORK-PREFIX/PREFIX-LENGTH] [{ftn | ilm}] [detail]
Parameters
NETWORK-PREFIX/
PREFIX-LENGTH
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
None.
EXEC Mode.
Level: 3.
This command is used to display the MPLS global configuration.
This example shows how to display the MPLS global configuration.
(Optional) Specifies the interface that will displayed. If no interface is specified, all
MPLS enabled interfaces' information will be displayed.
None.
EXEC Mode.
Level: 3.
This command is used to display MPLS enabled interfaces.
This example shows how to display MPLS enabled interfaces.
Status
-------
Up
Down
(Optional) Specifies the IP prefix for FEC. If not specified, dispay all FECs.
359