D-Link DXS-3600-16S Manual page 496

49-3 qcn cnm-transmit-priority
This command is used to configure the IEEE 802.1p priority for transmitting Congestion Notification Messages
(CNMs). Use the no form of this command to reset to the default setting.
qcn cnm-transmit-priority PRIORITY-VALUE
no qcn cnm-transmit-priority
Parameters
PRIORITY-VALUE
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# qcn cnm-transmit-priority 1
DXS-3600-32S(config)#
49-4 qcn cnpv
This command is used to assign IEEE 802.1p priority as Congestion Notification Priority Value (CNPV), and configure
the default settings for all ports. Use the no form of this command to delete a priority from CNPV.
qcn cnpv CNPV-PRIORITY-VALUE [admin-defense-mode {disable | interior | interior-ready | edge} |
alternate-priority PRIORITY-VALUE | defense-mode-choice {admin | auto} | cp-creation {enable | disable}]
no qcn cnpv CNPV-PRIORITY-VALUE
Parameters
CNPV-PRIORITY-VALUE
admin-defense-mode
{disable | interior |
interior-ready | edge}
alternate-priority
PRIORITY-VALUE
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the IEEE 802.1p priority value for all Congestion Notification Messages
(CNMs). The valid priority range of CNMs is 0 to 7
Priority value is 0.
Global Configuration Mode.
Level: 3.
Use the command to configure the priority of Congestion Notification Messages
which are transmitted by the Switch.
This example shows how to configure the priority of Congestion Notification
Messages to 1.
Specifies the IEEE 802.1p priority value to be the Congestion Notification Priority
Value (CNPV). The valid priority range of CNPV is 0 to 7.
(Optional) Specifies the default CND defense mode for this CNPV on all interfaces.
This setting can be overridden by admin-defense-mode of per-interface.
disable:
The congestion notification capability is administratively disabled for this priority:
interior: The priority parameter of frames input are not remapped to or from this
priority, and the frames are transmitted without CN-TAG ;
interior-ready: The priority parameter of frames input are not remapped to or
from this priority, and CN-TAGs won't be stripped off when transmitting the
frames;
edge: The priority parameter of frames input at this priority are remapped to an
alternate value, frames at other priorities are not remapped to this priority, and
the frames are transmitted without CN-TAG .
If not specified, the default administrative defense mode is interior.
(Optional) Specifies a priority value to which this priority value is to be remapped
when the receiving frame with a dot1p priority equal to the specified CNPV at Edge
port. The valid priority range is 0 to 7. This value can be overridden by alternate-
priority of per-interface. If not specified, the default alternate priority is 0.
488