D-Link DXS-3600-16S Manual page 664

Dxs-3600 series layer 2/3 managed 10gbe switch
Hide thumbs Also See for DXS-3600-16S:
Table of Contents

Advertisement

no maximum routes
Parameters
limit
warn-threshold
warning-only
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# ip vrf VPN-A
DXS-3600-32S(config-vrf)# maximum routes 100 warning-only
DXS-3600-32S(config-vrf)#
72-7 rd
This command is used to set the route distinguisher of one VRF.
rd route-distinguisher
Parameters
route-distinguisher
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# ip vrf VPN-A
DXS-3600-32S(config-vrf)# rd 100:1
DXS-3600-32S(config-vrf)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the maximum number of routes within the VRF. Its ranges from 1 to 16384.
Specifies the warning threshold percent of limit. A warning message will be printed
when the routes number reaches the threshold and no more routes can be written
into the hardware. Its range is 1% to 100%.
Specifies when the routes number reaches the limit. One warning message will be
printed. More routes can still be written into hardware.
By default, no limit is defined to a VRF instance.
VRF Configuration Mode.
Level: 15.
This command is used to limit how many routes can be allowed within the VRF.
Please note this limit only applies to the active route. If the user only wants to get a
warning, set the warning-only option.
Use the command show ip vrf details vrf-name to check the settings.
This example shows how to set the VRF VPN-A's routes limit to 100.
Specifies the VRF's route distinguisher, which is used to prepend an 8-bytes value to
an IPv4 prefix to create a VPN-IPv4 prefix.
By default, no route distinguisher is set for one VRF.
VRF Configuration Mode.
Level: 15.
This command is used to set the VRF's route distinguisher to form unique VPN-IPv4
prefix. One VRF has only one route distinguisher and cannot be changed if it has
been set to one value.
Use the command show ip vrf to check the settings.
This example shows how to create a VRF instance VPN-A and set its route
distinguisher.
656

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents