Ip Igmp Snooping Version - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan 1
DXS-3600-32S(config-vlan)#no ip igmp snooping max-response-time
DXS-3600-32S(config-vlan)#
24-8 ip igmp snooping query-interval
This command is used to configure the interval between general queries sent by IGMP Snooping querier. To restore
the default value, use the no form of this command.
ip igmp snooping query-interval SECONDS
no ip igmp snooping query-interval
Parameters
SECONDS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan 1
DXS-3600-32S(config-vlan)#ip igmp snooping query-interval 60
DXS-3600-32S(config-vlan)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan 1
DXS-3600-32S(config-vlan)#no ip igmp snooping query-interval
DXS-3600-32S(config-vlan)#

24-9 ip igmp snooping version

This command is used to configure the IGMP version in IGMP Snooping. To restore the default version, use the no
form of this command.
ip igmp snooping version {1 | 2 | 3}
no ip igmp snooping version
Parameters
{1 | 2 | 3}
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to restore the default value of IGMP Snooping max
response time on VLAN 1.
Specifies the amount of time in seconds between general query transmissions. The
range is 1 to 31744 seconds.
125 seconds.
Interface Configuration Mode.
Level: 8
The query interval is the interval between General Queries sent by the Querier. By
varying the query interval, an administrator may tune the number of IGMP messages
on the network; larger values cause IGMP Queries to be sent less often.
To verify your configuration, you can use show ip igmp snooping.
This example shows how to configure the IGMP Snooping query interval to be 60
seconds on VLAN 1.
This example shows how to restore the default value of IGMP Snooping query
interval on VLAN 1.
Specifies the three version numbers, ranging 1 to 3.
271