D-Link DXS-3600-16S Manual page 16

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#dot1x control-direction in
DXS-3600-32S(config-if)#
2-5 dot1x timeout
This command is used to configure the IEEE 802.1X timers.
dot1x timeout {quiet-period <sec 0-65535> | reauth-period <sec 1-65535> | server-timeout <sec 1-65535> |
supp-timeout <sec 1-65535> | tx-period <sec 1-65535>}
Parameters
quiet-period <sec 0-
65535>
reauth-period <sec 1-
65535>
server-timeout <sec 1-
65535>
supp-timeout <sec 1-
65535>
tx-period <sec 1-65535>
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
The configuration for this command on a specific port won't be in operation if you
don't configure the port as an IEEE 802.1X PAE authenticator by using the 'dot1x
pae authenticator' command.
When the port is in the force-unauthorized state or in the unauthorized state after
authentication, the traffic is controlled based on the setting of this command.
When the port is in the force-authorized state or becomes authorized after
authentication, the traffic will be allowed in both directions.
This example shows how to specify the direction of traffic through Ethernet port 1.
The direction is set as unidirectional.
Number of seconds that the switch will be in the quiet state in the wake of a failed
authentication process. The range is 0 to 65535
Number of seconds between re-authentication attempts. The range is 1 to 65535.
Number of seconds that the switch will wait for the request from the authentication
server before timing out the server. The range is 1 to 65535.
Number of seconds that the switch will wait for the response from the supplicant
before timing out the supplicant. The range is 1 to 65535.
Number of seconds that the switch will wait for a response to an EAP-Request or
Identity frame from the supplicant before retransmitting the request. The range is 1
to 65535
The default quiet period when authentication fails is 60 seconds (quiet-period).
The default re-authentication interval when authentication succeeds is 3600 seconds
(reauth-period).
The default timeout value waiting for a response from RADIUS is 30 seconds
(server-timeout).
The default timeout value waiting for a reply from Supplicant is 30 seconds (supp-
timeout).
The default transmission interval from the Authenticator to the Supplicant is 30
seconds (tx-period).
Interface Configuration Mode.
Level: 8
The 'dot1x timeout reauth-period' command is in operation only if you have
enabled re-authentication by using the 'dot1x re-authentication interface
configuration' command.
8