D-Link DXS-3600-16S Manual page 491

48-21 show mls qos rate-limit
This command is used to show the information about the rate limit on the interface.
show mls qos rate-limit [interface INTERFACE-ID [,|-]]
Parameters
interface INTERFACE-ID
[,|-]
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show mls qos rate-limit interface tenGigabitEthernet 1/0/1
Interface: TenGigabitEthernet1/0/1
rate limit:
input no limit
Effective no limit
output no limit
Effective no limit
queue rate limit:
QID: 0 minimum rate no limit
QID: 1 minimum rate no limit
QID: 2 minimum rate no limit
QID: 3 minimum rate no limit
QID: 4 minimum rate no limit
QID: 5 minimum rate no limit
QID: 6 minimum rate no limit
QID: 7 minimum rate no limit
DXS-3600-32S#
48-22 show mls qos scheduler
This command is used to show the information for the queue scheduling algorithm.
show mls qos scheduler [interface INTERFACE-ID [,|-]]
Parameters
interface INTERFACE-ID
[,|-]
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
(Optional) Specifies the interface ID you want to display.
None.
Privileged EXEC Mode.
Level: 15
If no interface ID is specified, then bandwidth information of all interfaces will be
displayed.
This example shows how to display the rate information of tenGigabitEthernet 1/0/1.
maximum rate no limit
maximum rate no limit
maximum rate no limit
maximum rate no limit
maximum rate no limit
maximum rate no limit
maximum rate no limit
maximum rate no limit
(Optional) Specifies the interface ID you want to display.
None.
Privileged EXEC Mode.
Level: 15
483